QuadFusion Documentation
M3D HomeGithub Repository
  • Welcome
  • Facebook Group
  • Getting Started
    • Critical Warnings & Information
    • Unboxing & Inventory
    • Getting Connected
    • Updating Firmware
    • Updating your Control Board Settings
    • Changing Homing Offsets
    • First Print
    • Getting Started: Where to Go From Here
  • Printer Installation
    • M3D Crane
    • M3D ProMega
    • CR-10S
    • Prusa i3 MK2S
    • Duet Maestro Wiring
  • Beginner Guides
    • Beginner: Preparation
    • Beginner: QuadFusion Assembly
    • Beginner: Moving the Motors
    • Beginner: Introduction to G-Code Commands
    • Beginner: Software Layers
    • Beginner: What is Slicing?
    • Beginner: Printing the Print
    • Beginner: Where to Go From Here
  • Electrical Guides
    • The Electrical Standard
  • Firmware Guides
    • Adjusting Homing Macros
    • Macros
  • Printing Guides
    • Slicers and Printer Settings
    • Heating & Temp Sensor
    • Loading and Unloading Filament
    • (NEW) Loading and Unloading Filament
    • Filament Success Guide
      • ABS-R
      • PLA
    • Filament Extrusion Rate
    • Tool Definitions
  • Color Printing
    • Setting Up
    • MELT
    • Slic3r Multi-Material
  • Troubleshooting Guides
    • Troubleshooting Duet Web Console
    • My Drives / Tools are Backwards
    • Heater Troubleshooting
  • Maintenance Guides
    • What You'll Need
    • Temperature Calibration
    • Changing Nozzles
  • Community Guides
    • Community Guide Template
Powered by GitBook
On this page

Maintenance Guides

This chapter contains guides that explain how to preform maintenance on the QuadFusion.

What You'll NeedTemperature CalibrationChanging Nozzles
PreviousHeater TroubleshootingNextWhat You'll Need

Last updated 6 years ago