QuadFusion Documentation
M3D HomeGithub Repository
  • Welcome
  • Facebook Group
  • Getting Started
    • Critical Warnings & Information
    • Unboxing & Inventory
    • Getting Connected
    • Updating Firmware
    • Updating your Control Board Settings
    • Changing Homing Offsets
    • First Print
    • Getting Started: Where to Go From Here
  • Printer Installation
    • M3D Crane
    • M3D ProMega
    • CR-10S
    • Prusa i3 MK2S
    • Duet Maestro Wiring
  • Beginner Guides
    • Beginner: Preparation
    • Beginner: QuadFusion Assembly
    • Beginner: Moving the Motors
    • Beginner: Introduction to G-Code Commands
    • Beginner: Software Layers
    • Beginner: What is Slicing?
    • Beginner: Printing the Print
    • Beginner: Where to Go From Here
  • Electrical Guides
    • The Electrical Standard
  • Firmware Guides
    • Adjusting Homing Macros
    • Macros
  • Printing Guides
    • Slicers and Printer Settings
    • Heating & Temp Sensor
    • Loading and Unloading Filament
    • (NEW) Loading and Unloading Filament
    • Filament Success Guide
      • ABS-R
      • PLA
    • Filament Extrusion Rate
    • Tool Definitions
  • Color Printing
    • Setting Up
    • MELT
    • Slic3r Multi-Material
  • Troubleshooting Guides
    • Troubleshooting Duet Web Console
    • My Drives / Tools are Backwards
    • Heater Troubleshooting
  • Maintenance Guides
    • What You'll Need
    • Temperature Calibration
    • Changing Nozzles
  • Community Guides
    • Community Guide Template
Powered by GitBook
On this page
  1. Getting Started

Unboxing & Inventory

PreviousCritical Warnings & InformationNextGetting Connected

Last updated 6 years ago